Operation Manual
Table Of Contents
- Contents
- Guide to the appliance 5
- Warning and Safety instructions 7
- Caring for our environment 12
- Before using for the first time 14
- To open the door 14
- To close the door 14
- Safety lock 14
- Water softener 15
- To call up the water hardness level in the display 17
- Before using the appliance for the first time, you require: 18
- Filling the salt reservoir 18
- Salt indicator 19
- Rinse aid 21
- Adding rinse aid 21
- Rinse aid indicator 22
- Setting the rinse aid dosage 23
- Loading the dishwasher 24
- Operation 33
- Additional functions 39
- Cleaning and care 46
- Problem solving guide 51
- Maintenance 59
- After sales service 61
- Programme chart 62
- Optional accessories 66
- Electrical connection 67
- Plumbing 68
- Technical data 70
Memory
You can use the Memory function to
save the last programme selected.
Instead of the indicator light for the
ECO programme, the indicator light for
the last programme selected will come
on when the dishwasher is switched off
and back on again or the door is
opened and then closed at the end of a
programme.
^
Switch the dishwasher off using the
On/Off button K.
^
Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the On/Off
button K.
Keep the Start/Stop button pressed in
until the Start/Stop indicator light
comes on.
If this does not happen, start the
procedure again from the beginning.
^ Press the Delay start button six times.
The Delay start indicator will flash
briefly six times at intervals.
The flashing sequence in the display
shows what the current setting is.
–
"p1": The Memory function is
activated.
–
"p0": The Memory function is
deactivated.
^
If you want to change the setting,
press the Start/Stop button.
The setting is now stored in memory.
^
Switch the dishwasher off using the
On/Off button K.
Additional functions
43