Operation Manual
Table Of Contents
- Contents
- Guide to the appliance 5
- Warning and Safety instructions 7
- Caring for our environment 12
- Before using for the first time 14
- To open the door 14
- To close the door 14
- Safety lock 14
- Water softener 15
- To call up the water hardness level in the display 17
- Before using the appliance for the first time, you require: 18
- Filling the salt reservoir 18
- Salt indicator 19
- Rinse aid 21
- Adding rinse aid 21
- Rinse aid indicator 22
- Setting the rinse aid dosage 23
- Loading the dishwasher 24
- Operation 33
- Additional functions 39
- Cleaning and care 46
- Problem solving guide 51
- Maintenance 59
- After sales service 61
- Programme chart 62
- Optional accessories 66
- Electrical connection 67
- Plumbing 68
- Technical data 70
General problems
Problem Possible cause Remedy
The time display is
dark.
The Start/Stop
indicator is flashing
slowly.
The time display has
switched off automatically
to save energy (Standby
mode).
Press any button.
This switches off Standby.
Detergent residue is
left in the dispenser at
the end of a
programme.
The dispenser was still
damp when detergent was
added.
Make sure the dispenser is
dry before adding
detergent.
The detergent
dispenser lid cannot
be closed properly.
Clogged detergent residue
is blocking the catch.
Clean the detergent from
the catch.
At the end of a
programme there is a
film of moisture on the
inside of the door and
the interior walls.
This is caused by the
drying system and does
not indicate a fault.
The moisture will dissipate
after a while.
Water remains in the
wash cabinet at the
end of a programme.
Before rectifying the
problem:
– Switch the dishwasher
off using the On/Off
button K.
The filter combination in
the wash cabinet is
clogged.
Clean the filter
combination. See
"Cleaning and care".
The drain pump or
non-return valve may be
blocked.
Clean the drain pump or
the non-return valve. See
"Maintenance".
The drain hose is kinked. Remove any kink from the
drain hose.
Problem solving guide
54