Operation Manual

Water inlet/drain fault
Problem Possible cause Remedy
The following fault
message appears in
the display:
2 Open stopcock
The stopcock is closed. Open the stopcock fully.
2 Inlet
Before rectifying the problem:
–
Switch the dishwasher off
using the On/Off button K.
Water intake is
restricted.
–
Open the stopcock fully and
start the programme again.
– Clean the water inlet filter
(see "Maintenance").
– The water pressure at the
intake is lower than 30 kPa
(0.3 bar).
Seek professional advice.
Problem solving guide
46