Operating instructions

Display
The duration of the programme
selected appears in hours and minutes
in the display before the programme
begins. During the programme, the
time left until the end of the programme
is displayed.
Symbols appear to indicate which
stage the programme is at:
1 Pre-wash / Soak
8 Main wash
% Interim rinse
( Final rinse
G Drying
O Finished
The time displayed may vary with the
same programme. This can be due,
among other factors, to the water
temperature at each intake, the
reactivation process, the type of
detergent, the amount of crockery and
how dirty it is.
When a programme is selected for the
first time, the display shows an average
time for a cold water intake.
The times shown in the Programme
chart refer to standard test loads and
temperatures.
Each time a programme is run, the
electronic unit takes the new conditions
into account, and calculates the time
required.
Standby
To save energy, the dishwasher will
switch to Standby mode a few minutes
after the last time a button has been
pressed or at the end of the
programme. The display and the
indicators lights will go out, and only
the Start/Stop indicator will flash slowly.
The dishwasher will not switch to
Standby mode whilst a programme is
running.
^
Press any button to switch the
display and indicator lights back on
again.
If the dishwasher is not switched off at
the end of the programme and the door
is not opened, it will switch off
completely after a few minutes in
Standby mode (see "Settings menu,
Optimise standby").
Operation
34