Operating instructions

Optimise standby
To save energy, the dishwasher will
switch to Standby mode a few minutes
after the last time a button has been
pressed or at the end of the
programme. The display and the
indicator lights will go out, and only the
Start/Stop indicator will flash slowly.
The dishwasher will not switch to
Standby mode whilst a programme is
running.
If the dishwasher is not switched off at
the end of the programme and the door
is not opened, it will switch off
completely after a few minutes in
Standby mode.
The Optimise standby function can be
deactivated if wished. The display and
the indicator lights will not go out, and
the time lapse before the dishwasher
switches off will increase to approx. 6
hours, resulting in higher energy
consumption.
^ Select the setting you want, and
confirm your selection with the
middle button underneath the
display.
Replenish salt and rinse aid
reminders
If you only ever use combination
products containing salt and rinse aid
in your dishwasher, you can switch
both of these reminders off if you wish.
The DetergentAgent function will not be
affected by this.
^
Select the setting you want, and
confirm your selection with the
middle button underneath the
display.
If you switch to using detergent that
does not contain salt or rinse aid, it
is important to remember to
replenish the salt and rinse aid and
to switch the reminders back on.
Soak
You can use the Soak function in the
programme selected for loosening very
stubborn food residues from pots, pans
and casserole dishes. It is not available
for every programme.
If you are using powder dishwasher
detergent, add approx.5gto
compartment I.
^
Select the setting you want, and
confirm your selection with the
middle button underneath the
display.
Once set, the function will remain active
for the programmes for which it is
available, until the setting is changed.
Settings menu
70