Operation Manual

Guide to the appliance
8
Display
General
The display is used to select or set the
following:
– the programme
– the FlexiTimer (Delay start)
– the Settings menu
The display can show the following:
– the stage the programme is at
– the estimated time left for the pro‐
gr
amme to run
– the energy and water consumption
(EcoF
eedback)
– any relevant fault messages and in‐
formation
To save energy, the dishwasher
switches off aft
er a few minutes if you
do not press any buttons during this
time.
To switch the dishwasher back on
again, press the  button.
Settings menu
The Settings menu is used to alter the
d
ishwasher's electronics to suit differ‐
ent requirements. You access the Set‐
tings menu by pressing a specific but‐
ton combination (see "Settings menu").
The arrows in the display indicate fur‐
ther optio
ns. You can use the  ar‐
row buttons next to the display, as ap‐
propriate, to select these further op‐
tions.
The OK butt
on is used to confirm a
message or setting and also to move to
the next menu or another level.
The option which is selected will have a
tick  ne
xt to it.
To exit a sub-menu, use the 
arrow
buttons to select the Back  option in
the display and confirm your choice
with
OK.
If you do not pr
ess any of the buttons
for several seconds, the display with re‐
turn to the previous level. You may
need to enter your settings again.