Operation Manual

Switching on
Make sure the spray arms are not
obstructed
Close the door.
Open the stopcock, if it is closed.
Press the “On/Off” button (14).
The light ring around the programme
selector (18) and the decimal point in
the time display (15) light up.
Starting a programme
When selecting a programme, refer to
the programme chart at the end of the
operating instructions.
Turn the programme selector (18)
clockwise or anti-clockwise to the re-
quired programme.
The running time of the programme se-
lected shows in the time display (15) in
hours and minutes. The “Time left” indi-
cator light next to the time display (15)
and the “Start” indicator light (21) light
up.
Note:
If selecting “Delay Start” or “Top Solo”
this must be done before the pro-
gramme is started (see “Additional
functions”).
Press the “Start” button (21).
The programme cycle begins. The
“Start” indicator light (21) goes out and
the “Wash/Rinse” indicator light (16)
comes on.
Do not finish a programme prema-
turely.
Important programme stages (e. g.
reactivating the water softener)
could be omitted.
Operating the dishwasher
32