Operating instructions

Preparing the DOS dispensers
The agents can be filled into 10 l plastic
containers, which are colour coded for
the relevant dispensing system.
When first commissioning, or when the
message FILL DOS 1 CONTAINER
and/or FILL DOS 2, 3 or 4 CONTAINER
flashes in the display after switching on
or at the end of a programme, replace
the storage containers with new ones,
or refill them with the relevant agent.
If the message CHECK DISPENSING
SYSTEM 1 and/or CHECK DISPENSING
SYSTEM 2, 3 or 4 flashes in the display,
check the storage containers,
dispensing tubes and hoses. Then
replace the storage containers with new
ones, or refill them with the relevant
agent.
The programme will stop automatically.
When first commissioning or when
the message CHECK DISPENSING
SYSTEM... appears, start the
DOS-FILL Programme to vent the
dispensing system (see "Venting the
dispensing system").
,
Take great care when handling
liquid agents and additives. These
may contain irritant or corrosive
ingredients.
Please follow the manufacturer’s
safety instructions.
Wear protective gloves and goggles.
Fill the containers with the relevant
agent
^
Switch the machine off using the
master switch.
^ Open the service panel out from the
right hand side, and swing it out to
the left.
^
Take the storage containers out, open
them and fill with the agent required,
(observe the colour code).
Dispensing liquid chemical agents
31