Operating instructions

Warning and Safety
instructions
,
These warning and safety
instructions are in addition to those
given at the beginning of this
booklet.
H
2
O
2
solution must only be used in
the special containers and
adapters supplied by the Ecolab and
Dr. Weigert companies.
Important: observe the
manufacturer's safety instructions
as given on their safety data sheet.
Be especially careful when
handling H
2
O
2
solution. It is an
irritant chemical.
Observe all current safety instructions
pertaining to its use.
Wear protective gloves and goggles.
Empty containers must be
disposed of in accordance with the
manufacturer's instructions.
H
2
O
2
solution must not be mixed
with other chemicals. This could
cause a serious chemical reaction, e. g.
the release of harmful vapours or
gases.
Connecting the H
2
O
2
solution
container
The connection hose for the H
2
O
2
solution container is identified by a
black label. It is supplied without an
adapter because the system for
drawing the solution out of the
container varies depending on supplier.
^
Connect the supplier's adapter to the
connection hose (black).
^
Then connect this to the H
2
O
2
solution container.
^ Then start the DOS2-FILL
programme.
Unlike with other chemical agents, the
H
2
O
2
solution container must be fully
emptied before it is exchanged for a
new one.
Do not replace the H
2
O
2
solution
container with a new one until the FILL
DOS 2 CONTAINER message is
displayed. After connecting the new
container you must run the DOS2-FILL
programme.
If the message CHECK DISPENSING
SYSTEM 2 appears in the display you
must check the container and all
dispensing tubes and hoses. The
programme will stop automatically.
Special features - OXIVARIO
54