Operating instructions

Fault Cause Solution
The refill salt message
"Recharge" is flashing.
Because no regeneration
salt was added, the water
softener could not be
reactivated.
Carefully fill the reservoir
with reactivation salt.
A few minutes after the
start of a program, the
"Fill/Drain" indicator
light flashes and the
program stops.
Before addressing the
error:
–
Turn the program
selector to the 12
o'clock position f. The
error message is
erased.
–
Press the "ON/OFF"
button to switch off the
machine.
Error message: F..E:
There is a problem with the
water inflow.
– Open the water valve
completely.
– Clean the filter in the
water inlet.
– The flow pressure at the
water connection is too
low. Contact a qualified
plumber for advice.
Then:
–
Switch the
washer-disinfector on.
–
Restart the program.
Troubleshooting
52