Operation Manual

Problem Possible cause Remedy
The dishwasher stops
running, the in operation
control light is flashing
rapidly.
Before rectifying the prob
-
lem you must:
Switch the dishwasher off.
Water inlet fault.
The indicator light "In
-
let/Drain", seen when the
door is open, is flashing.
–
Open the stopcock
fully.
–
Check the water inlet
filter and clean if nec
-
essary, see “Cleaning
the water inlet filter”.
–
The water pressure at
the intake is lower than
0.3 bar. Seek profes
-
sional advice.
There is a fault with the
drainage system.
Water remains in the wash
cabinet at the end of a
programme.
The indicator light "In-
let/Drain", seen when the
door is open, is flashing.
– Clean the filter combi-
nation, see “Cleaning
and Care”.
– Clean the drain pump,
see “Cleaning the drain
pump and non-return
valve”.
– Clean the non-return
valve, see “Cleaning
the drain pump and
non-return valve”.
–
Remove any kink in the
drain hose.
Problem solving guide
46