Operation Manual

Programme sequence
indicator lights (14)
After a programme has been started
the current stage of the programme is
indicated by the programme sequence
indicator lights.
Time display (18)
The running time of the programme se
-
lected shows in hours and minutes in
the time display before a programme is
started. During a programme the time
left until the end of the programme is
displayed. The “Time left” indicator light
next to the time display lights up.
The time displayed in the time display
may vary with the same programme.
This is partly because of the water inlet
temperature at each intake and partly
because of the amount and soiling level
of the crockery.
When the dishwasher is first switched
on the display shows an average time
value for a cold water intake.
Values shown in the programme chart
refer to standard test loads and temper
-
atures.
Each time a programme is run the elec
-
tronic unit takes into account the new
conditions and calculates the time re
-
quired. This new figure is then dis
-
played when this programme is next
selected.
At the end of a programme
A programme has finished when a 0
shows in the time display (18).
The indicator lights for the programme
just run and for any additional functions
selected for it will continue to light up.
These will go out when the dishwasher
door is opened.
The dishwasher can now be opened
and unloaded (see “Unloading the
dishwasher”).
^
For safety’s sake it is advisable to al
-
ways switch the dishwasher off if you
do not wish to start another
programme immediately.
Switching off
At the end of a programme:
^ Press the "On/Off" button (15).
The dishwasher continues to use
electricity until switched off using the
“On/Off” button.
If the dishwasher is not to be used for a
longer period of time, e. g. whilst on
holiday, the stopcock should be turned
off.
Operation
33