Operation Manual

Problem Possible cause Remedy
The indicator light "Wa
-
ter inlet" is flashing and
the programme does not
continue.
Before rectifying the prob
-
lem you must:
–
Press the "Start/Stop"
button for at least one
second.
All the programme button
indicator lights will light
up.
–
Start the programme
again.
The stopcock is closed. Open the stopcock fully.
The water inlet filter is
blocked.
Before rectifying the prob
-
lem you must:
– Press the "Start/Stop"
button for at least one
second.
All the programme button
indicator lights will light
up.
– Switch the dishwasher
off using the "On/Off"
button.
then:
–
Clean the water inlet fil
-
ter, see "Solving prob
-
lems".
The water pressure at the
intake is lower than
0.3 bar.
Seek professional advice.
Problem solving guide
48