Operating instructions/Installation instructions

Table Of Contents
IMPORTANT SAFETY INSTRUCTIONS
9
The dishwasher must not be installed underneath a cooktop. The
high temperatures radiated by cooktops could damage the dish-
washer below. For the same reason, the dishwasher must not be in-
stalled next to open fires or other appliances that give off heat, such
as heaters etc., not normally found in a kitchen.
Ensure that the connection data on the dishwasher’s data plate
(fuse rating, frequency, and voltage) match the electricity supply.
This data must correspond in order to avoid the risk of damage to
the dishwasher. Compare these before connecting the appliance to
the electricity supply. If in any doubt, consult a qualified service
technician.
Do not connect the dishwasher to the electricity supply until it has
been fully installed and any adjustment has been made to the door
springs.
The dishwasher may only be operated if the door opening mecha-
nism is working correctly. Otherwise there could be a risk of danger
while the automatic door opening mechanism (depending on the
model) is active.
To check that the door opening mechanism is working correctly:
- The door springs must be evenly adjusted on both sides. They are
correctly adjusted when the door remains stationary when left half
open (approx. 45° opening angle). It is also important that the
door cannot fall open.
- The door locking pins automatically retract when the door opens
at the end of the drying phase.
Power bars and extension cords do not guarantee the required
safety of the appliance (risk of fire). Do not connect the dishwasher
to the electricity supply using a power bar or an extension cord.
The dishwasher must not be used in a non-stationary location
(e.g., on a ship).