Operating Instructions

Frequently Asked Questions
86
Water intake fault
Problem Possible cause and solution
The buzzer sounds.
One of the following
fault messages appears
in the display:
Water intake fault
Open the water supply
The water supply is turned off.
 Turn on the water supply fully.
Water intake Before fixing the fault:
 Turn the dishwasher off using the  sensor.
There is a problem with the water intake.
 Turn on the water supply fully and start the pro-
gram again.
 Clean the water intake filter (see "Frequently asked
questions").
 The flow pressure at the connection point is lower
than 7.25 psi.
Contact a plumber.
The following message
appears in the display
during the Energy Saver
program:
 Intake temp. too low
The intake water has not reached the required tem-
perature of 120°F (45°C) (see "Water connection, Wa-
ter intake").
 Start the program again.
 If the fault message appears again, select a differ-
ent program.