User Manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Guide to the appliance
- Caring for the environment
- Using for the first time
- Caring for the environment
- Loading the dishwasher
- Comparison tests
- Detergents
- Operation
- Options
- Programme chart
- Programme options
- Cleaning and care
- Problem solving guide
- Service
- Optional accessories
- Installation
- Technical data
- Settings
- Opening the Settings menu
- Changing settings
- Closing the Settings menu
- Language
- Time of day
- Water hardness
- AutoDos (automatic dispensing)
- Rinse aid
- Miele@home
- Remote control
- RemoteUpdate
- SmartStart
- EcoStart
- Consumption (EcoFeedback)
- Display brightness
- Volume
- Refill reminders
- AutoOpen
- Extra clean
- Extra dry
- Software version
- Showroom programme
- Factory default
Using for the first time
29
Replenishing salt
When Refill salt appears in the
display wait until the end of the
programme and then refill the salt
reservoir.
Confirm with OK.
The salt refill indicator will go out.
Risk of corrosion due to saline
solution.
Saline solution that runs out can
cause corrosion in the wash cabinet
and to the dishwasher load.
Each time you have opened the salt
reservoir lid, immediately run the
65 °C QuickPowerWash programme
with the Express option and
without any dishes. This will dissolve
and remove any traces of salt from
the wash cabinet.
After the salt reservoir has been filled,
the refill reminder may still appear in the
display if the salt concentration has not
yet reached the correct level. In this
case, confirm with OK again.
The salt refill indicator is deactivated if
the dishwasher is set to a water
hardness below 0.9mmol/l (5 °dH -
German scale).