Operating Guide
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the appliance
- Caring for the environment
- Before using for the first time
- Settings
- Opening the settings menu
- Changing settings
- Closing the settings menu
- Language
- Time of day
- Water hardness
- AutoDos (AutoDos)
- Rinse Aid
- Miele@home
- Remote control
- RemoteUpdate
- SmartStart
- EcoStart
- Display brightness
- Volume
- Refill reminders
- AutoOpen
- Extra Clean
- Extra Dry
- 2nd interim rinse
- Hygiene cycle
- Software version
- Showroom program
- Factory default
- Copyrights and licenses for the communication module
- Caring for the environment
- Loading the dishwasher
- Detergents
- Operation
- Options
- Program overview
- Program options
- Cleaning and care
- Frequently Asked Questions
- Customer Service
- Optional accessories
- Installation
- Sound emission testing
Operation
67
Display of program duration
The estimated duration of the selected
program appears on the display before
the program begins. If the door is
opened during the program, the time
left until the end of the program is dis-
played.
Each program phase is indicated by a
symbol:
Pre-rinse/Soak
Main wash
Interim rinse
Final rinse
Drying
Finish
The displayed duration may vary for the
same program. It is influenced by, for
example, the temperature of the incom-
ing water, the reactivation cycle of the
water softener, the detergent type, and
the amount of dishes and how soiled
they are.
When a program is selected for the first
time, the display will show the average
program duration for a cold water con-
nection.
The program durations shown under
“Program overview” refer to standard
test loads and temperatures.
Each time a program is run, the control
module calculates the program duration
required depending on the temperature
of the water taken into the dishwasher
and the amount of dishes.
Starting a program
Start the program by closing the door
within 4seconds of the last press of a
button.
If necessary, confirm the previously
displayed message with OK.
The in-operation indicator comes on to
show that a program has been started.
If you do not close the door within
4seconds, the message Continue with
OK will appear in the display.
The program cannot be started until
you confirm the message by press-
ing the OK button and close the door
within 4seconds.
During a program sequence, you can
use OK to display the name of the
program that is currently running when
the door is open.
Risk of scalding due to hot wa-
ter.
During operation, water in the dish-
washer may be very hot.
During operation, only open the door
with extreme caution.