Operation Manual

Programming hob zone cooking
times
Please note it is not possible to use
this programme for hobs which
have the KSE 200 control unit.
A symbol in the display shows which
hob zone is being programmed.
* = front left zone
# = front right zone
t = both front zones
Make sure the correct symbol is show-
ing in the display before programming
in times.
When a cooking process has been
pre-selected the hob zone symbol
flashes, and the time of day is dis-
played. The hob control light goes out.
When the process starts running, the
symbol for the chosen hob zone lights
up.
At the end of cooking time
– the hob switches off automatically,
– an audible tone sounds for approx.
5 seconds.
– The symbol for the selected hob
zone and the symbol ")" flash. The
symbol ")" does not flash when a
cooking end time is entered for the
oven.
Both the audible tone and the visual
display can be cancelled by:
– Pressing the ")" button.
To use the oven again, the hob zone
selector switch must first of all be
turned to "0".
– Turning the hob zone selector switch
to "0".
If the audible tone is not switched off,
as described earlier, it will repeat at
5 minute intervals as a reminder that
the end time has been reached. This
reminder continues for up to an hour.
Timer - use
36