Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and safety instructions
- Caring for the environment
- Guide to the appliance
- Controls
- Using the appliance
- Features
- Data plate
- Scope of delivery
- Accessories supplied and available to order
- Side runners
- Baking tray, universal tray and rack with non-tip notches
- FlexiClip runners HFC 70-C
- Fitting the FlexiClip runners
- Removing the FlexiClip runners
- Round baking trays
- Grilling and roasting insert HGBB 71
- Perforated gourmet baking tray HBBL 71
- Baking stone HBS 70
- HUB gourmet oven dishes HBD gourmet oven dish lids
- Food probe
- Handle HEG
- Accessories for cleaning and care
- Safety features
- PerfectClean treated surfaces
- Before using for the first time
- Settings
- Min. minder
- Main and sub-menus
- Energy saving tips
- Operation
- Automatic programmes
- Further applications
- Baking
- Roasting
- Grilling
- Cleaning and care
- Unsuitable cleaning agents
- Removing normal soiling
- Removing stubborn soiling (excluding the runners)
- Stubborn soiling on the FlexiClip runners
- Pyrolytic cleaning of the oven compartment
- Door removal
- Dismantling the door
- Fitting the door
- Removing the side runners with FlexiClip runners
- Lowering the top heat/grill element
- Problem solving guide
- Service
- Installation
- Cooking charts
- Notes for test institutes
Installation
*INSTALLATION*
81
Installing the oven
For safety reasons, the oven may
only be used when it has been fully
installed.
The oven requires a sufficient supply
of cool air for efficient operation. The
required supply of cool air must not
be excessively heated by other heat
sources (e.g. solid fuel stoves).
The following must be observed
when installing the appliance:
Make sure that the shelf that the
oven sits on does not touch the wall.
Do not fit heat insulation strips to the
side walls of the housing unit.
Connect the oven to the electrical
supply.
Carrying the oven by the door handle
could damage the door.
Use the recessed grips on the side of
the housing to carry the appliance.
It is a good idea to remove the door
(see “Cleaning and care” – “Removing
the door”) and the accessories before
installing the appliance. This makes
the oven lighter when you push it into
the housing unit and you do not run
the risk of lifting it by the door handle
by mistake.
Push the oven into the housing unit
and align it.
Open the door, if you have not
removed it.
Use the screws supplied to secure
the oven to the side walls of the
housing unit.
Refit the door if necessary (see
“Cleaning and care” – “Fitting the
door”).