Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and safety instructions
- Caring for the environment
- Guide to the appliance
- Controls
- Using the appliance
- Features
- Data plate
- Scope of delivery
- Accessories supplied and available to order
- Side runners
- Baking tray, universal tray and rack with non-tip notches
- FlexiClip runners HFC 70-C
- Fitting the FlexiClip runners
- Removing the FlexiClip runners
- Grilling and roasting insert HGBB 71
- Perforated gourmet baking tray HBBL 71
- Round baking trays
- Baking stone HBS 70
- HUB gourmet oven dishes HBD gourmet oven dish lids
- Handle HEG
- Accessories for cleaning and care
- Safety features
- PerfectClean treated surfaces
- Before using for the first time
- Settings
- Min. minder
- Main and sub-menus
- Energy saving tips
- Operation
- Moisture plus
- Automatic programmes
- Further applications
- Baking
- Roasting
- Grilling
- Cleaning and care
- Unsuitable cleaning agents
- Removing normal soiling
- Removing stubborn soiling (excluding the runners)
- Stubborn soiling on the FlexiClip runners
- Pyrolytic cleaning of the oven compartment
- Descale
- Door removal
- Dismantling the door
- Fitting the door
- Removing the side runners with FlexiClip runners
- Lowering the top heat/grill element
- Problem solving guide
- Service
- Installation
- Cooking charts
- Notes for test institutes
- Conformity declaration
- Copyrights and licences
Cleaning and care
69
Descale
The frequency of descaling will depend
on the water hardness level in your
area.
The descaling process can be run at
any time.
However, to ensure that the oven
functions correctly, you will be
automatically prompted to run the
descaling process for the steam
injection system after a certain number
of cooking processes.
The oven will count down in the display
the last 10 cooking processes that can
be run before it needs to be descaled.
You will then not be able to run any
operating mode or automatic
programme using moisture assistance.
These operating modes can only be
used again after you have carried out a
descaling process. All other operating
modes and automatic programmes
without moisture assistance can still be
used.
Descaling process sequence
Once the descaling process has been
started it must be completed through
to the end. It cannot be cancelled.
Descaling takes approx. 90minutes and
consists of several steps:
1. Preparing the descaling process
2. Drawing in the descaling solution
3. Activation phase
4. Rinse 1
5. Rinse 2
6. Rinse 3
7. Residual water evaporation
Preparing the descaling process
You will need a container of approx.
1litre capacity.
A plastic tube (with suction cup) is
supplied with your oven so that you
do not have to hold the container with
the descaling agent underneath the
water intake pipe.
We recommend using the descaling
tablets supplied. They have been
specially developed for Miele for
optimum results.
Tip: Miele descaling tablets are
available to order from the Miele
webshop, from the Miele Customer
Service Department or from your Miele
dealer.
Other descaling agents, which contain
other acids besides citric acid and/or
other undesirable substances, such as
chlorides for example, could cause
damage.
Moreover, the descaling result
required could not be guaranteed if
the descaling solution was not of the
appropriate concentration.
Fill the container with approx. 600ml
of cold tap water and thoroughly
dissolve one descaling tablet in it.
Carrying out the descaling process
Select Further.
Select Descale.
If the functions and automatic
programmes that use added moisture
are already locked, the descaling
process can be started immediately by
touching OK.