Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and safety instructions
- Caring for the environment
- Guide to the appliance
- Controls
- Using the appliance
- Features
- Data plate
- Scope of delivery
- Accessories supplied and available to order
- Side runners
- Baking tray, universal tray and rack with non-tip notches
- FlexiClip runners HFC 70-C
- Fitting the FlexiClip runners
- Removing the FlexiClip runners
- FlexiClip runners HFC 71
- Fitting and removing FlexiClip runners
- Grilling and roasting insert HGBB 71
- Perforated gourmet baking tray HBBL 71
- Round baking trays
- Baking stone HBS 60
- HUB gourmet oven dishes HBD gourmet oven dish lids
- Handle HEG
- Accessories for cleaning and care
- Safety features
- PerfectClean treated surfaces
- Before using for the first time
- Settings
- Min. minder
- Main and sub-menus
- Energy saving tips
- Operation
- Moisture plus
- Automatic programmes
- Further applications
- Baking
- Roasting
- Grilling
- Cleaning and care
- Unsuitable cleaning agents
- Removing normal soiling
- Removing stubborn soiling (excluding the runners)
- Stubborn soiling on the FlexiClip runners
- Pyrolytic cleaning of the oven compartment
- Descale
- Door removal
- Dismantling the door
- Fitting the door
- Removing the side runners with FlexiClip runners
- Lowering the top heat/grill element
- Problem solving guide
- Service
- Installation
- Cooking charts
- Notes for test institutes
- Conformity declaration
Moisture plus
51
Evaporate res. moisture
When cooking using the addition of
moisture, the water will be equally
distributed between the bursts of steam
and used up as long as the programme
is not interrupted.
However, if a programme using the
addition of moisture is manually
interrupted before all the bursts of
steam have been released or if there is
a power cut, the water for these unused
bursts of steam will remain in the steam
injection system.
The next time Moisture plus or an
automatic programme with moisture is
used, Evaporate res. moisture will appear
in the display with the options.
It is best to start the evaporation of
residual water straight away so that
only fresh water is used during a food
cooking programme.
Danger of injury caused by
steam.
Steam can cause severe scalding.
Do not open the door whilst steam is
being released.
Depending on the amount of water,
evaporation of residual water can take
up to 30minutes.
The oven compartment is heated up
and the remaining water is evaporated,
causing condensation to form in the
oven compartment and on the door.
Be sure to wipe away the
condensation from the door and oven
compartment once the compartment
has cooled down.
To start residual water evaporation
immediately
Risk of injury caused by steam.
Steam can cause severe scalding.
Do not open the door during a burst
of steam.
Select a function or an automatic
programme that uses moisture.
The request Evaporate res. moisture
appears.
Confirm withOK.
A time appears.
The Evaporate residual water process
will then start. You can follow the time
counting down in the display.
The time indicated will depend on the
amount of residual water left in the
steam injection system. During the
evaporation process, this time may be
adjusted by the system according to
the amount of water currently present.
At the end of the residual water
evaporation process, a buzzer will
sound and Finished will appear.
You can now select a function to start a
cooking process or run an automatic
programme with added moisture.
Whilst residual water is evaporating,
moisture will condense on the door
and in the oven compartment. It is
absolutely essential to remove this
moisture after the oven has cooled
down.