Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and safety instructions
- Caring for the environment
- Guide to the appliance
- Controls
- Using the appliance
- Features
- Data plate
- Scope of delivery
- Accessories supplied and available to order
- Side runners
- Baking tray, universal tray and rack with non-tip notches
- FlexiClip runners HFC 70-C
- Fitting the FlexiClip runners
- Removing the FlexiClip runners
- FlexiClip runners HFC 71
- Fitting and removing FlexiClip runners
- Grilling and roasting insert HGBB 71
- Perforated gourmet baking tray HBBL 71
- Round baking trays
- Baking stone HBS 60
- HUB gourmet oven dishes HBD gourmet oven dish lids
- Handle HEG
- Accessories for cleaning and care
- Safety features
- PerfectClean treated surfaces
- Before using for the first time
- Settings
- Min. minder
- Main and sub-menus
- Energy saving tips
- Operation
- Moisture plus
- Automatic programmes
- Further applications
- Baking
- Roasting
- Grilling
- Cleaning and care
- Unsuitable cleaning agents
- Removing normal soiling
- Removing stubborn soiling (excluding the runners)
- Stubborn soiling on the FlexiClip runners
- Pyrolytic cleaning of the oven compartment
- Descale
- Door removal
- Dismantling the door
- Fitting the door
- Removing the side runners with FlexiClip runners
- Lowering the top heat/grill element
- Problem solving guide
- Service
- Installation
- Cooking charts
- Notes for test institutes
- Conformity declaration
Cleaning and care
70
Other descaling agents, which contain
other acids besides citric acid and/or
other undesirable substances, such as
chlorides for example, could cause
damage.
Moreover, the descaling result
required could not be guaranteed if
the descaling solution was not of the
appropriate concentration.
Fill the container with approx. 600ml
of cold tap water and thoroughly
dissolve one descaling tablet in it.
Carrying out the descaling process
Select Further.
Select Descale.
If the functions and automatic
programmes that use added moisture
are already locked, the descaling
process can be started immediately by
touching OK.
Push the universal tray into the top
shelf level as far as it will go to collect
the descaling solution after it has
been used. Confirm the message
shown with OK.
Place the container with the
descaling solution on the floor of the
oven compartment.
Attach one end of the plastic tube to
the water intake pipe. Place the other
end of the plastic tube in the bottom
of the descaling solution container
and secure the plastic tube to the
container with the suction cup.
Confirm withOK.
The water intake process will begin. You
will hear the noise of the pump.
You can interrupt and resume the
intake process at any time by
selecting OK.
The amount of solution specified may
exceed the amount which is actually
taken in. Some of the solution may
therefore be left in the container at the
end of descaling.
A message will appear to confirm that
the intake process is complete.
Confirm withOK.
The activation phase will begin. You
can watch the time counting down in
the display.
Leave the container in the oven with
the tube still connected to the water
intake pipe. Top the container up with
approx. 300ml of water, as the
system will need to draw in some
more liquid during the activation
phase.
The system will take in more liquid at
approximately 5minute intervals. You
will hear the noise of the pump.