Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and safety instructions
- Caring for the environment
- Guide to the appliance
- Controls
- Using the appliance
- Features
- Data plate
- Scope of delivery
- Accessories supplied and available to order
- Side runners
- Baking tray, universal tray and rack with non-tip notches
- FlexiClip runners HFC 70-C
- Fitting the FlexiClip runners
- Removing the FlexiClip runners
- FlexiClip runners HFC 71
- Fitting and removing FlexiClip runners
- Grilling and roasting insert HGBB 71
- Perforated gourmet baking tray HBBL 71
- Round baking trays
- Baking stone HBS 60
- HUB gourmet oven dishes HBD gourmet oven dish lids
- Handle HEG
- Accessories for cleaning and care
- Safety features
- PerfectClean treated surfaces
- Before using for the first time
- Settings
- Min. minder
- Main and sub-menus
- Energy saving tips
- Operation
- Moisture plus
- Automatic programmes
- Further applications
- Baking
- Roasting
- Grilling
- Cleaning and care
- Unsuitable cleaning agents
- Removing normal soiling
- Removing stubborn soiling (excluding the runners)
- Stubborn soiling on the FlexiClip runners
- Pyrolytic cleaning of the oven compartment
- Descale
- Door removal
- Dismantling the door
- Fitting the door
- Removing the side runners with FlexiClip runners
- Lowering the top heat/grill element
- Problem solving guide
- Service
- Installation
- Cooking charts
- Notes for test institutes
- Conformity declaration
Installation
*INSTALLATION*
90
Electrical connection
Danger of injury!
Installation, repairs and other work
by unqualified persons could be
dangerous. Miele cannot be held
liable for unauthorised work.
Connection to the electrical supply
must be carried out by a suitably
qualified and competent person in
accordance with local and national
safety regulations. Ensure power is
not supplied to the appliance until
after installation or repair work has
been carried out.
All electrical work should be carried out
by a suitably qualified and competent
Miele approved service technician in
strict accordance with current national
and local safety regulations (BS 7671 in
the UK).
Connection should be made via a fused
connection unit or a suitable isolator,
which complies with national and local
safety regulations, and the on/off switch
should be easily accessible after the
appliance has been installed.
If the switch is not accessible after
installation (depending on country) an
additional means of disconnection must
be provided for all poles.
Switches with a minimum all-pole
contact gap of 3mm are suitable for
isolating the appliance. These include
circuit breakers, fuses and protective
devices.
Connection data
The required connection data are given
on the data plate located on the oven
trim visible when the door is open.
Ensure that these match the mains
supply.
When contacting Miele, please quote
the following:
- Model number
- Serial number
- Connection data (voltage/frequency/
maximum connected load)
When replacing the cable supplied
with another cable or changing the
connection, only cable type H05VV-F
with a suitable cross-sectional area
(CSA) may be used.
Oven
The wires in the mains lead are
coloured as follows:
Green/yellow = earth
Blue = neutral
Brown = live
WARNING - THIS APPLIANCE
MUST BE EARTHED
For extra safety it is advisable to protect
the appliance with a suitable residual
current device (RCD).
Maximum connected load: see data
plate.