Operating Instructions and Installation Instructions

Moisture plus
63
Preparing and starting the water
intake process
 Fill a suitable container with the
required amount of fresh tap water.
 Open the door.
 Pull the water intake pipe forwards
(located on the left below the fascia
panel).
 Immerse the end of the water intake
pipe in the container with the tap
water.
 Confirm withOK.
The water intake process will begin.
The amount of water actually drawn up
into the oven may be less than the
amount specified as required, leaving a
small amount in the container.
You can interrupt and resume the
intake process at any time by
selecting OK.
 At the end of the water intake
process, remove the water container
and close the door.
The sound of the pump running can be
heard. Residual water in the water
intake pipe is being drawn into the
oven.
The oven heating and cooling fan will
switch on. The required and actual
temperatures will appear.
You will see the temperature increasing.
A buzzer will sound when the set
temperature is reached for the first time.
If you have selected Time-controlled
bursts of steam, you can check the
injection time in advance by touching
 Info.