Operation Manual

Stubborn soiling (does not
apply to the FlexiClip runners)
Spilt fruit and roasting juices may
cause lasting discolouration or matt
patches on enamelled surfaces.
This discolouration is permanent but
will not affect the efficiency of the
finish. Do not try to remove this
discolouration! Clean these
following the instructions given here.
^
Baked on deposits can be removed
with a glass scraper or a non-
abrasive stainless steel spiral pad.
^ Very stubborn soiling on
PerfectClean treated enamel can be
cleaned using Miele oven cleaner. It
must be applied to cold surfaces in
accordance with instructions on the
packaging.
Non-Miele oven spray must only be
used in a cold oven and for no longer
than a maximum of 10 minutes.
^
Leave the oven cleaner to take effect
for the prescribed time. You can
then also use the scouring pad on
the back of a washing-up sponge to
remove the soiling.
^
After cleaning, remove all oven
cleaning agent residues thoroughly
with clean water, and dry with a soft
cloth.
Stubborn soiling on the
FlexiClip runners
Never attempt to clean FlexiClip
telescopic runners in a dishwasher.
This would remove the special
grease which is essential for their
smooth functioning.
For stubborn surface soiling or if the
bearings become sticky with spilled
fruit juices proceed as follows:
^
Soak the FlexiClip runners for approx.
10 minutes in a solution of hot water
and washing-up liquid. If necessary
use the back of a washing-up
sponge to remove the soiling. The
bearings can be carefully cleaned
with a soft brush.
Cleaning may cause some
discolouration or fading in places,
however this will not affect the
functioning of the runners in any way.
Cleaning and care
71