Operating and Installation Instructions

Moisture Plus
63
Preparing and starting the water
intake process
 Fill a suitable container with the
required amount of fresh tap water.
 Open the door.
 Pull the water intake pipe forward
(located below the control panel on
the left).
 Place the end of the water intake pipe
in the water container with the tap
water.
 Confirm with OK.
The water intake process will begin.
The amount of water actually drawn up
into the oven may be less than the
amount specified as required, leaving a
small amount in the container.
You can interrupt and restart the
intake process at any time by
selecting Stop or Start.
 Remove the water container after the
water intake process and close the
door.
You will hear the pump again briefly.
Residual water in the water intake pipe
is being drawn into the oven.
The oven heating and cooling fan will
turn on. The required and the actual
temperature will appear.
You will see the temperature rising on
the display. An audible signal will sound
when the set temperature is reached for
the first time.
If you have selected with timer, you can
check the time before steam is
released by selecting  Info.