Operating Manual

Frequently asked questions
83
Problem Possible cause and solution
The oven lighting does
not turn on.
The halogen bulb needs to be replaced.
 Danger of burns!
Make sure the heating elements are turned off and
all
owed to cool completely.
The lamp cover may be damaged if it falls.
When removing the cover hold it firmly so that it
does no
t fall. Place a towel on the oven floor and
open door to avoid damage.
 Discon
nect the appliance from the power supply.
 L
oosen the bulb cover with the tool supplied at the
back of the frame.
 Do not t
ouch the halogen blub with bare fingers.
Observe the manufacturers instructions.
Remove the halogen bulb.
 Replace it with a new halogen bulb (Sylvania
66740, 120 V, 40 W, G9, FS1).
 P
ress the bulb cover back into place.
 Recon
nect the oven to the electrical supply.
There is soiling in the
over aft
er the Self Clean
program.
The Self Clean program burns off soiling in the oven
and leaves it as ash.
 Using
a soft sponge, warm water and liquid dish
soap remove the ashes.
If coarse soiling remains, start the Self Clean
program again with a longer duration.