Operating Guide (Speed Oven & Gourmet Drawer)
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the range
- Control panel
- Using the appliance
- Features
- Before first use
- Operating the drawer
- Using the oven
- Settings
- Settings overview
- Opening the “ Settings ” menu
- Language
- Time
- Date
- Lighting
- Start screen
- Display
- Volume
- Units of Measurement
- Quick Microwave
- Popcorn
- Booster
- Recommended temperatures
- Recommended power levels
- Cooling fan run-on
- Proximity sensor ( MotionReact )
- Safety
- Miele@home
- Remote Control
- SuperVision
- RemoteUpdate
- Lift-up panel
- Electrical version
- Calibrate temperature
- Software version
- Legal information
- Showroom Program
- Factory default
- Alarm + Timer
- Main and submenus
- Microwave operation
- Quick Microwave
- Automatic Programs
- Special Modes
- MyMiele
- Favorites
- Baking
- Roasting
- Broiling
- Cleaning and care of the drawer
- Cleaning and care of the oven
- Frequently Asked Questions
- Customer Service
- Caring for the environment
- Declaration of conformity
- Copyrights and licenses
Before first use
43
Connecting the drawer via WPS
Your WiFi router must support WPS
(WiFi Protected Setup).
Turn the drawer off.
Press and hold the Durationsensor
button.
At the same time, touch the
Remotesensor button.
2h will light up constantly, 3h will flash
on and off.
The WPS connection must be started
on the drawer at the same time as on
the WiFi router.
Touch the Durationsensor button
after a few seconds.
After a short while, 2h will light up
constantly, and 3h and 4h will flash on
and off.
The drawer will be ready for connection
in the next 10minutes.
Start the WiFi connection on your
WiFi router.
When successfully connected, 2h and
3h will light up constantly.
Touch the Temperaturesensor button.
You have quit connection mode and
can now operate the drawer via the
Miele App.
If the connection fails, you have
probably not activated WPS on your
router quickly enough.
Repeat the steps above.
Tip: If your WiFi router does not support
WPS, please connect the drawer via the
Miele App.
Disconnecting the WiFi connection
(reset to factory settings)
To set up a new WiFi connection, the
existing WiFi connection must be
disconnected.
Turn the drawer off.
Press and hold the
Temperaturesensor button.
At the same time, touch the
Remotesensor button.
With an existing WiFi connection, 2h
and 3h will light up constantly.
The drawer will be ready for
disconnection in the next 10minutes.
Touch the Temperaturesensor
button.
2h will light up constantly, 3h will flash
on and off.
After a few seconds, 2h and 3h will
start flashing on and off. The
connection has now been
disconnected.
Touch the Durationsensor button.
You have quit disconnection mode.
A new connection can now be set up.
Ensure that all personal data has
been removed before disposing of,
selling, or operating a used range.
Disconnect the drawer from the WiFi
connection. This is the only way to
ensure that all personal data has
been removed and the previous
owner will no longer be able to
access the drawer.