Operation Manual
Table Of Contents
- Contents
- Description of the appliance 5
- Caring for the environment 7
- Warning and Safety instructions 8
- How to save energy 16
- Switching on and off 18
- The correct temperature 22
- Temperature and door alarm 25
- Super cool 27
- Storing food in the refrigerator section 28
- Storing food in the MasterFresh zone 31
- Arranging the interior fittings 34
- Automatic defrost 37
- Cleaning and care 38
- Problem solving guide 41
- Noises 44
- After Sales / Guarantee 45
- Note for test institutes 46
- Electrical connection 47
- Installation advice 48
- Building-in dimensions 54
- Installation 56
- Tools and accessories required 56
- Weight of the door front 57
- Building into a peninsular run 57
- Building-in at the end of a run of units 57
- Aligning the building-in niche 58
- Checking the building-in niche 58
- Before installation 58
- Preparing the niche 59
- Placing the appliance in the niche 63
- Aligning the appliance 64
- Securing the appliance in the niche 65
- Preparing the furniture front 67
- Securing and aligning the furniture door 69
- Securing the covers 70
- Fitting the plinth facing 71
- Fitting the air separator 72
- Addresses 75
Anti-tipping mechanism
The anti-tipping mechanism a
supplied is used to secure the
building-in niche b to the wall,
preventing the appliance from tipping
forwards.
,
Danger of tipping.
The building-in niche must be
securely fixed to the wall behind
using a number of screws to avoid
the appliance tipping when it is
fixed into the niche later.
Use two anti-tipping mechanisms for
each appliance or four for each
side-by-side pair of appliances.
^
Place the anti-tipping mechanisms a
on the left- and right-hand sides of
the building-in niche, leaving <10
mm distance to the side walls.
^
Mark the drilling position onto the
niche back wall and top panel
through the holes in the anti-tipping
mechanisms.
^ Put the anti-tipping mechanisms in a
safe place - they will be required
later.
Fixing screws for different uses and
types of material are supplied in the
accompanying pack. If these are not
suitable for the anti-tipping
mechanism in your installation, you
will need to secure it by alternative
means.
^
Secure the building-in niche to the
wall.
Installation
60