Operation Manual
Table Of Contents
- Contents
- Description of the appliance 5
- Caring for the environment 7
- Warning and Safety instructions 8
- How to save energy 16
- Switching on and off 18
- The correct temperature 22
- Temperature and door alarm 25
- Super cool 27
- Storing food in the refrigerator section 28
- Storing food in the MasterFresh zone 31
- Arranging the interior fittings 34
- Automatic defrost 37
- Cleaning and care 38
- Problem solving guide 41
- Noises 44
- After Sales / Guarantee 45
- Note for test institutes 46
- Electrical connection 47
- Installation advice 48
- Building-in dimensions 54
- Installation 56
- Tools and accessories required 56
- Weight of the door front 57
- Building into a peninsular run 57
- Building-in at the end of a run of units 57
- Aligning the building-in niche 58
- Checking the building-in niche 58
- Before installation 58
- Preparing the niche 59
- Placing the appliance in the niche 63
- Aligning the appliance 64
- Securing the appliance in the niche 65
- Preparing the furniture front 67
- Securing and aligning the furniture door 69
- Securing the covers 70
- Fitting the plinth facing 71
- Fitting the air separator 72
- Addresses 75
Preparing the furniture front
^
Load the door shelves in the
refrigerator door.
^ Open the appliance door as far as it
will go.
^ Unscrew the installation aids l and
angle trim m from the door.
^ Put the angle trim m and screws in a
safe place - they will be required
later.
^ Take the cover off the light contact
switch.
^
Close the appliance door.
^ Measure gap X between the
adjusting bar and the upper edge of
the adjacent furniture front.
^ Remove the two nuts from the
appliance door, and place them in a
safe place - they will be required
later.
^ Place the furniture front on a firm
surface, with the external side facing
downwards (place on a blanket or
similar to avoid it becoming
scratched).
Installation
67