Operating instructions/Installation instructions

Installation
*
I
N
S
T
A
L
L
A
T
I
O
N
*
53
Furniture door panel
Horizontal and vertical gaps
Depending on the style of kitchen
furniture the thickness and edge radius
of the furniture door and the gap that
runs around the door, vertically and
horizontally, are specified.
It is essential to pay attention to the
following!
–Horizontal gap
The gap between the appliance
furniture door and the housing unit door
above or below it must be at least
3mm.
– Vertical gap
If the gap between the appliance
furniture door and the adjoining
housing unit door or wall on the
hinged side is too small, the
appliance door could collide with the
adjoining housing unit door or wall
when opened.
It may be necessary to adjust the
size of this gap to suit the thickness
and edge radius of the appliance
furniture door.
This must be taken into consideration
when planning your kitchen and when
replacing an old appliance with a new
one to ensure the installation conditions
required are met.
Appliance
furniture
door
thickness
A [mm]
Gap X [mm] for different
edge radiiB
R0 R1.2 R2 R3
≥16 - 19 Min. 3
20 5 4 4 3.5
21 5.5 5 4.5 4
22 6.5 6 5.5 5
Adjoining kitchen furniture front
A=Furniture front thickness
B=Edge radius
X=Gap
Adjoining side wall
A=Furniture front thickness
B=Edge radius
X=Gap
Tip: Fit a spacer between the housing
unit carcase and the side wall. This way
you will get a sufficiently wide gap.