Operating instructions

The warmest temperature will show in
the display for about 1 minute. The
display will then revert to showing the
current temperature in the freezer
section.
At the end of a power cut, the
appliance will start operating again at
the last temperature setting selected.
. . . the super freeze or super cool
indicator light is not lit up although
the appliance is working.
The indicator light is defective. Call the
Service Department.
...you cannot switch the appliance
off.
The safety lock has been activated.
. . . the interior light in the refrigerator
section is not working.
^ Was the refrigerator section door left
open for too long? The lighting
switches itself off automatically after
approx. 15 minutes.
If this is not the case, then the lamp is
defective:
^
Disconnect the appliance from the
mains. Switch off at the wall and
withdraw the plug from the socket, or
disconnect the mains fuse or remove
the screw-out fuse in countries where
this is applicable.
^
Press the sides of the lamp cover
inwards (1), disengage the cover (2)
and unclip it at the rear.
^
Replace the lamp.
Lamp specification:
220 - 240 V, max. 25 W, E 14 fitting.
^ Screw the new lamp into the
connection. Ensure it goes in
correctly and make sure that seal (3)
makes a tight fit.
^
Replace the cover by clipping it in at
the rear and then pressing it in at the
sides.
. . . the floor of the refrigerator is wet.
The drain hole is blocked.
^
Clean the condensate channel and
drain hole.
Problem solving guide
38