Operating and Installation Guide

The correct temperature
68
Setting the temperature
 Touch the sensor control to set the
temperature.
The previously set temperature will ap-
pear.
 Use the and sensor controls to
set the temperature. Keeping your fin-
ger on the sensor control changes
the temperature continuously.
 Confirm the temperature setting with
OK or wait approx. 8seconds after
the last touch of the sensor. This tem-
perature will be automatically
adopted.
Tip: The new temperature setting can
also be confirmed and adopted by clos-
ing the appliance door.
The temperature display always shows
the required temperature.
If you have adjusted the temperature,
wait for approximately 6hours if the
appliance is not very full and for ap-
proximately 24hours if the appliance
is full before checking the temperature
display. It will take this long for an accu-
rate reading to be given.
 If, after this time, the temperature is
still too high or too low, adjust it
again.
Adjusting the temperature in the dry
compartment of the MasterFresh
zone
The temperature in the dry compart-
ment of the MasterFresh zone is main-
tained at approx. 32°F (0°C).
However, if you would like it to be
warmer or colder, you can adjust the
temperature slightly (see “Selecting ad-
ditional settings – Adjusting the temper-
ature in the MasterFresh zone (dry com-
partment)”).
Tip: You can select a lower setting for
storing, for example, particularly deli-
cate fish. A slightly higher temperature
is preferable for storing ready-to-eat
food, for example.
Temperature range
The temperature in the refrigerator sec-
tion can be set between 36°F (2°C) and
46°F (8°C).
The temperature in the dry compart-
ment in the MasterFresh zone can be
set between 30°F (-1°C) and 37°F (3°C).