Operating and Installation Guide

Cleaning and care
85
Replacing the Active AirClean
filters
The Active AirClean filters in the refrig-
erator section need to be replaced ap-
prox. every 6months.
Change Active AirClean Filter will appear
on the display.
 Confirm the message with OK.
 To remove the holder for the Active
AirClean filters, press against the re-
tainers on both sides of the holder
from the rear and pull the holder
downwards diagonally from the
frame.
 Remove the used Active AirClean fil-
ters and place the new Active Air-
Clean filters with the surrounding
edge pointing downwards in the
holder.
 To replace the holder, press against
the retainers on both sides of the
holder from the rear and clamp it into
the gap on the frame from below.
The holder can be fixed under any
shelf in the refrigerator section.
Once the Active AirClean filters have
been replaced, the Active AirClean filter
display must be reset using Settings
mode on the display (see “Selecting
additional settings – Resetting the Dis-
play Active AirClean Filter”).
New Active AirClean filters (both with
and without a holder) can be obtained
from Miele Service, your local dealer,
or via the Miele website.
After cleaning
 Replace all shelves and accessories
in the appliance.
 Switch the appliance back on.
 Switch on the SuperCool function for
a while so that the refrigerator section
can cool down quickly.
 Place food back in the appliance and
close the door.