Operating and Installation Guide

Frequently Asked Questions
89
Messages in the display
Message Possible cause and solution
The warning sounds
and the message Close
the door appears on the
display.
The appliance door is open.
 Close the appliance door.
 If you wish to turn the alarm off early, touch the
sensor control OK on the display.
The alarm will stop.
The temperature display
is dark and the sym-
bol is shown on the dis-
play.
The Sabbath Mode function is switched on. The in-
terior lighting is switched off and the refrigeration ap-
pliance is cooling down.
 You can switch off Sabbath mode at any time (see
“Selecting additional settings – Switching Sabbath
Mode on or off”).
“F Please contact Miele
Technical Service.” ap-
pears in the display and
an alarm sounds.
There is a fault.
 Make a note of the fault message if necessary.
 Contact Miele Service.
 To turn the alarm off, touch the symbol.
The error message does not disappear from the dis-
play until the error has been rectified.
The voltage level is too high/low.
 Observe the connection data under “Electrical
connections”.
 Contact Miele Service if necessary.
 To turn the alarm off, touch the symbol.
The error message does not disappear from the dis-
play until the error has been rectified.
 is shown in the dis-
play. The machine does
not get cold, but the
machine controls are
working.
Demo Mode  is switched on. Demo mode allows the
appliance to be presented in the showroom without
the cooling system being turned on. Do not activate
this setting for domestic use.
 Switch off Demo mode  (see “Selecting additional
settings”, section “Switching off Demo Mode ”).