Operating and Installation Guide
ManualsBrandsMiele ManualsAll Refrigerator- No Freezer24 Inch Panel Ready Smart Refrigerator Column with 13 Cu. Ft. Capacity, WifiConnect, DynaCool, Push2open, IceMaker, MasterFresh, SuperCool, Sabbath Mode, Active AirClean Filter, BrilliantLight, MasterSensor, and Energy Star: Panel Ready, Right Hinge
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Installation
- Installation location
- Installation notes
- Installation dimensions
- Dimensions of the cabinet front
- Building in the appliance
- Before starting...
- Tools required
- Weight of cabinet front
- Aligning the installation niche
- Checking the installation niche
- Before installation
- Preparing the installation niche
- Pushing the appliance into the niche
- Aligning the refrigeration appliance
- Securing the appliance in the niche
- Preparing the cabinet fronts
- Securing and aligning the cabinet front
- Mounting the fixing brackets
- Securing the covers
- Mounting the cover in a side-by-side combination
- Securing the toe-kick ventilation grille and toe-kick cover
- Limiting the opening angle of the appliance door
- Electrical connection
- Saving energy
- Guide to the appliance
- Accessories
- Before first use
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Automatic SuperCool
- Door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Automatic defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Customer Service
- Declaration of conformity
- Copyrights and licenses
Installation
*INSTALLATION*
14
Installation location
This appliance should be installed in a
dry, well-ventilated room.
When deciding where to install your
refrigeration appliance, please bear in
mind that it will use more energy if
installed near to a heater, a range, or
another appliance that gives off heat.
Direct sunlight should also be avoided.
The higher the room temperature, the
longer the compressor runs and the
higher the energy consumption of the
refrigeration appliance.
When installing the refrigeration
appliance, please note the following:
- The electrical socket must be easily
accessible in an emergency and not
concealed behind the appliance.
- The plug and power cord must not
touch the rear of the refrigeration
appliance as they could be damaged
by vibrations from the appliance.
- Do not plug in other appliances
behind the refrigeration appliance.
If installation near a heat source is
unavoidable, observe the following
minimum distances between the
appliance and the heat source:
- At least 1 1/4" (3cm)
to electric or gas stoves
- At least 11 3/4" (30cm)
to oil or coal-based stoves
If it is not possible to observe these
minimum distances, an isolation plate
must be installed between the
refrigeration appliance and the heat
source.
Climate class
The refrigeration appliance is designed
for use within the climate class (room
temperature range) SN-T. Do not use in
a climate class for which it is not
designed.
Climate class Room
temperature
SN 50°F to 90°F /
10°C to 32°C
N 60°F to 90°F /
+16°C to +32°C
ST 60°F to 100°F /
+16to +38°C
T 60°F to 109°F /
+16to +43°C
A lower room temperature will cause
the compressor to switch off for longer
periods. This can cause the internal
temperature in the refrigeration
appliance to rise with the risk of food
deteriorating and going off.