Operating and Installation Guide
ManualsBrandsMiele ManualsAll Refrigerator- No Freezer24 Inch Panel Ready Smart Refrigerator Column with 13 Cu. Ft. Capacity, WifiConnect, DynaCool, Push2open, IceMaker, MasterFresh, SuperCool, Sabbath Mode, Active AirClean Filter, BrilliantLight, MasterSensor, and Energy Star: Panel Ready, Right Hinge
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Installation
- Installation location
- Installation notes
- Installation dimensions
- Dimensions of the cabinet front
- Building in the appliance
- Before starting...
- Tools required
- Weight of cabinet front
- Aligning the installation niche
- Checking the installation niche
- Before installation
- Preparing the installation niche
- Pushing the appliance into the niche
- Aligning the refrigeration appliance
- Securing the appliance in the niche
- Preparing the cabinet fronts
- Securing and aligning the cabinet front
- Mounting the fixing brackets
- Securing the covers
- Mounting the cover in a side-by-side combination
- Securing the toe-kick ventilation grille and toe-kick cover
- Limiting the opening angle of the appliance door
- Electrical connection
- Saving energy
- Guide to the appliance
- Accessories
- Before first use
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Automatic SuperCool
- Door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Automatic defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Customer Service
- Declaration of conformity
- Copyrights and licenses
Installation
*INSTALLATION*
42
Place the washers and nuts back
in position and tighten the nuts .
The cabinet front is now secured.
Now tighten the screws in the angle
trims .
Open the appliance door.
Remove the spacers from the
cabinet front.
Mounting the fixing brackets
The fixing bracket is used to secure the
cabinet front to the bottom of the
appliance door.
Do not mount the fixing bracket until
the appliance (or side-by-side
combination, if applicable) has been
installed and the cabinet front has
been aligned.
Open the appliance door as far as it
will go.
Slide the fixing bracket sideways
onto the screw at the bottom of the
appliance door.