Operating and Installation Guide

Selecting additional settings
71
Activating Miele@home
If you have already activated
Miele@home and then disconnected
the connection, you will need to
reactivate the connection.
 In Settings mode, use the and
sensor controls to select
Miele@home and select OK to confirm
your selection.
 Use the and sensor controls to
select Activate and select OK to
confirm your selection.
Activation successful will appear on the
display.
 Confirm the message with OK.
If the WLAN connection is active,  will
appear on the display.
Checking the WLAN connection
status
 In Settings mode, use the and
sensor controls to select
Miele@home and select OK to confirm
your selection.
 Use the and sensor controls to
select Connection status and select OK
to confirm your selection.
Information about the WLAN
connection status will then appear on
the display:
- connected: there is a strong
connection
- connected: there is an average
connection
- connected: there is a weak
connection
- disconnected
Setting up Miele@home again
If you have changed your WiFi network,
you can set up Miele@home again for
your appliance.
 In Settings mode, use the and
sensor controls to select
Miele@home and select OK to confirm
your selection.
 Use the and sensor controls to
select Set up again and select OK to
confirm your selection.
Reset configuration? will appear on the
display.
 Use the and sensor controls to
select Yes or No and select OK to
confirm your selection.
Resetting the network configuration
Reset the refrigeration appliance’s
settings to the default settings when
disposing of your refrigeration
appliance, selling it, or putting a used
refrigeration appliance into operation.
This will reset the network
configuration so that all personal data
is deleted from the refrigeration
appliance. This will also ensure that a
previous owner is no longer able to
access the refrigeration appliance.
 Reset the settings of the refrigeration
appliance as described under
“Resetting the settings to their default
settings”.