Operating and Installation Guide
ManualsBrandsMiele ManualsAll Refrigerator- No Freezer24 Inch Panel Ready Smart Refrigerator Column with 13 Cu. Ft. Capacity, WifiConnect, DynaCool, Push2open, IceMaker, MasterFresh, SuperCool, Sabbath Mode, Active AirClean Filter, BrilliantLight, MasterSensor, and Energy Star: Panel Ready, Left Hinge
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Installation
- Installation location
- Installation notes
- Installation dimensions
- Dimensions of the cabinet front
- Building in the appliance
- Before starting...
- Tools required
- Weight of cabinet front
- Aligning the installation niche
- Checking the installation niche
- Before installation
- Preparing the installation niche
- Pushing the appliance into the niche
- Aligning the refrigeration appliance
- Securing the appliance in the niche
- Preparing the cabinet fronts
- Securing and aligning the cabinet front
- Mounting the fixing brackets
- Securing the covers
- Mounting the cover in a side-by-side combination
- Securing the toe-kick ventilation grille and toe-kick cover
- Limiting the opening angle of the appliance door
- Electrical connection
- Saving energy
- Guide to the appliance
- Accessories
- Before first use
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Automatic SuperCool
- Door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Automatic defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Customer Service
- Declaration of conformity
- Copyrights and licenses
The correct temperature
79
Setting the temperature
Touch the sensor control to set the
temperature.
The previously set temperature will
appear.
Use the and sensor controls to
set the temperature. Keeping your
finger on the sensor control changes
the temperature continuously.
Confirm the temperature setting with
OK or wait approx. 8seconds after
the last touch of the sensor. This
temperature will be automatically
adopted.
Tip: The new temperature setting can
also be confirmed and adopted by
closing the appliance door.
The temperature display always shows
the required temperature.
If you have adjusted the temperature,
wait for approximately 6hours if the
appliance is not very full and for
approximately 24hours if the
appliance is full before checking the
temperature display. It will take this long
for an accurate reading to be given.
If, after this time, the temperature is
still too high or too low, adjust it
again.
Adjusting the temperature in the dry
compartment of the MasterFresh
zone
The temperature in the dry
compartment of the MasterFresh zone
is maintained at approx. 32°F (0°C).
However, if you would like it to be
warmer or colder, you can adjust the
temperature slightly (see “Selecting
additional settings – Adjusting the
temperature in the MasterFresh zone
(dry compartment)”).
Tip: You can select a lower setting for
storing, for example, particularly
delicate fish. A slightly higher
temperature is preferable for storing
ready-to-eat food, for example.
Temperature range
The temperature in the refrigerator
section can be set between 36°F (2°C)
and 46°F (8°C).
The temperature in the dry
compartment in the MasterFresh zone
can be set between 30°F (-1°C) and
37°F (3°C).