Operating and Installation Instructions

To reduce the risk of electrical
shock, disconnect the appliance
from the power supply by shutting
off the power main, tripping the
circuit breaker or unplugging the
power cord before maintenance.
Never use cleaning agents
containing abrasive substances
such as sand, soda, acids, chlorides
or chemical solvents.
Non-abrasive cleaning agents are
also unsuitable, as they can cause
matte areas to appear.
Only use a mild solution of warm
water and liquid dish soap to clean
this appliance.
Do not use a steam cleaner to clean
this appliance. Pressurized steam
could penetrate electrical
components and cause a short
circuit.
Do not allow water to get into the
electronic unit or lights.
The data plate located inside the
appliance must not be removed. It
contains information which is
required in the event of a service
call.
To better maintain your appliance
avoid the following:
–
cleaners containing soda, ammonia,
thinners, or chlorides
–
cleaners containing descaling
agents or lime removers,
–
abrasive cleaners,
–
stainless steel cleaners,
–
dishwasher soap (powder),
–
caustic (oven) cleaners,
–
scouring pads, steel wool, hard
brushes,
– glass cleaners,
– metal scrapers,
– eraser sponges,
– steam cleaning products.
Glass cleaners may be used to
clean the exterior. However do not
allow them to sit or "puddle", this can
cause damage to the surface.
Remove the cleaner promptly.
Cleaning and care
28