Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Installation
- Location
- Installation notes
- Specifications for the mains water connection
- Building-in dimensions
- Dimensions of front panels
- Installing the appliance
- Before starting ...
- Tools required
- Weight of the furniture fronts
- Aligning the building-in niche
- Checking the installation niche
- Before installation
- Preparing the building-in niche
- Pushing the refrigeration appliance into the building-in niche
- Aligning the refrigeration appliance
- Securing the refrigeration appliance in the building-in niche
- Preparing to install the front panels
- Securing and aligning the furniture front
- Mounting the fixing brackets
- Securing the covers
- Installing the cover in a side-by-side combination
- Securing the plinth ventilation grille and plinth panel
- Limiting the opening angle of the appliance door
- Mains water connection
- Electrical connection
- Saving energy
- Guide to the appliance
- Accessories
- Initial commissioning
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Super cool and Super freeze
- Temperature and door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Freezing and storing food
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Water filter
- Problem solving guide
- Noises
- Service
- EU Conformity declaration
- UK Conformity declaration
- Copyrights and Licences
Cleaning and care
113
Cleaning the door seal
Risk of damage as a result of in-
correct cleaning.
If you treat the door seal with oils or
grease, it can become porous.
Do not use any oils or grease on the
door seal.
The door seal should be cleaned reg-
ularly with clean water, and then
wiped dry with a soft cloth.
Cleaning the ventilation gaps
A build-up of dust will increase the en-
ergy consumption of the appliance.
The ventilation gaps should be
cleaned on a regular basis with a
brush or vacuum cleaner (you could
use a Miele vacuum cleaner dusting
brush, for example).
Cleaning the water filter (In-
tensiveClear mesh filter)
Depending on the quantity of ice cubes
produced, the IntensiveClear mesh filter
must be cleaned approx. every
6months.
Clean the water filter will appear in the
display.
Confirm the message with OK.
1.
2.
Turn the cap of the filter cartridge
anti-clockwise until it is in the vertical
position 1.) and slide it out of the filter
opening 2.).
3.
Pull the filter out of the back of the fil-
ter cartridge 3.).