Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Installation
- Location
- Installation notes
- Specifications for the mains water connection
- Building-in dimensions
- Dimensions of front panels
- Installing the appliance
- Before starting ...
- Tools required
- Weight of the furniture fronts
- Aligning the building-in niche
- Checking the installation niche
- Before installation
- Preparing the building-in niche
- Pushing the refrigeration appliance into the building-in niche
- Aligning the refrigeration appliance
- Securing the refrigeration appliance in the building-in niche
- Preparing to install the front panels
- Securing and aligning the furniture front
- Mounting the fixing brackets
- Securing the covers
- Installing the cover in a side-by-side combination
- Securing the plinth ventilation grille and plinth panel
- Limiting the opening angle of the appliance door
- Mains water connection
- Electrical connection
- Saving energy
- Guide to the appliance
- Accessories
- Initial commissioning
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Super cool and Super freeze
- Temperature and door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Freezing and storing food
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Water filter
- Problem solving guide
- Noises
- Service
- EU Conformity declaration
- UK Conformity declaration
- Copyrights and Licences
Cleaning and care
115
Replacing the Active AirClean
filters
The Active AirClean filters in the refri-
gerator section need to be replaced ap-
prox. every 6 months.
Change Active AirClean filter will appear on
the display.
Confirm the message with OK.
To remove the holder for the Active
AirClean filters, press against the re-
tainers on both sides of the holder
from the rear and pull the holder
downwards diagonally from the
frame.
Remove the used Active AirClean fil-
ters and place the new Active
AirClean filters with the surrounding
edge pointing downwards in the
holder.
To replace the holder, press against
the retainers on both sides of the
holder from the rear and clamp it into
the gap on the frame from below.
The holder can be fixed under any
shelf in the refrigerator section.
Once the Active AirClean filters have
been replaced, the Active AirClean filter
display must be reset using Settings
mode on the display (see “Selecting
additional settings – Resetting the Dis-
play Active AirClean filter ”).
New Active AirClean filters can be ob-
tained from the Miele Customer Ser-
vice Department, your Miele dealer or
the Miele website.