Operating instructions/Installation instructions

Problem solving guide
119
Problem Cause and remedy
The compressor is
switching on more fre-
quently and for longer
periods of time, so the
temperature in the ap-
pliance is dropping.
The ventilation gaps in the housing unit have been
covered or become too dusty.
 Do not block the ventilation gaps.
 Dust the ventilation gaps regularly.
The doors have been opened too frequently, or a
large amount of fresh food has been placed inside
and/or frozen at the same time.
 Only open the doors when necessary and for as
short a time as possible.
The required temperature will re-establish itself after
a while.
The doors are not properly closed. A thick layer of ice
may have formed in the freezer.
 Close the appliance doors.
The required temperature will re-establish itself after
a while.
If a thick layer of ice has formed, it will reduce effi-
ciency and increase the energy consumption.
 Defrost the appliance and clean it.
The ambient temperature is too high. The higher the
room temperature, the longer the compressor will run
for.
 See “Installation - Location”.
The appliance was not properly installed in the niche.
 See “Installing the appliance”.
The compressor is
switching on more fre-
quently and for longer
periods of time, so the
temperature in the ap-
pliance is dropping.
The temperature setting is too low.
 Adjust the temperature.
A large amount of food is being frozen at once.
 See “Freezing and storing food”.
The Super cool function is still switched on.
 You can switch off the Super cool function earlier
to save energy.
The Super freeze function is still switched on.
 You can switch off the Super freeze function earlier
to save energy.