Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Installation
- Location
- Installation notes
- Specifications for the mains water connection
- Building-in dimensions
- Dimensions of front panels
- Installing the appliance
- Before starting ...
- Tools required
- Weight of the furniture fronts
- Aligning the building-in niche
- Checking the installation niche
- Before installation
- Preparing the building-in niche
- Pushing the refrigeration appliance into the building-in niche
- Aligning the refrigeration appliance
- Securing the refrigeration appliance in the building-in niche
- Preparing to install the front panels
- Securing and aligning the furniture front
- Mounting the fixing brackets
- Securing the covers
- Installing the cover in a side-by-side combination
- Securing the plinth ventilation grille and plinth panel
- Limiting the opening angle of the appliance door
- Mains water connection
- Electrical connection
- Saving energy
- Guide to the appliance
- Accessories
- Initial commissioning
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Super cool and Super freeze
- Temperature and door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Freezing and storing food
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Water filter
- Problem solving guide
- Noises
- Service
- EU Conformity declaration
- UK Conformity declaration
- Copyrights and Licences
Problem solving guide
120
Problem Cause and remedy
The compressor comes
on less and less often
and for shorter periods
of time. The temperat-
ure in the refrigeration
appliance rises.
This is not a fault. The temperature setting is too
high.
Correct the temperature setting.
Check the temperature again after 24hours.
The frozen food begins to defrost.
The ambient temperature is too low for this refrigera-
tion appliance.
If the ambient temperature is too low, the com-
pressor will run less frequently. This may cause the
freezer section to become too warm.
See the information in “Installation – Installation
site”.
Increase the ambient temperature.
The compressor runs
continuously.
This is not a fault. To save energy, the compressor
runs at a lower speed, but for longer, when less
cooling is required.
Food has frozen to-
gether.
The food packaging was not dry when placed in the
freezer.
Use a blunt instrument, e.g. a spoon handle or
plastic scraper, to prise it apart carefully.
An alarm sounds. The appliance doors have been open for longer than
approx. 2minutes.
Close the appliance doors.
No alarm sounds des-
pite the appliance door
being open.
You have switched off the buzzer.
Switch the buzzer back on using Settings
mode.
The Sabbath mode function is switched on: the tem-
perature display is dark and the symbol is shown in
the display.
You can switch off Sabbath mode at any time (see
“Selecting additional settings – Switching Sabbath
mode on or off”).