Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Installation
- Location
- Installation notes
- Specifications for the mains water connection
- Building-in dimensions
- Dimensions of front panels
- Installing the appliance
- Before starting ...
- Tools required
- Weight of the furniture fronts
- Aligning the building-in niche
- Checking the installation niche
- Before installation
- Preparing the building-in niche
- Pushing the refrigeration appliance into the building-in niche
- Aligning the refrigeration appliance
- Securing the refrigeration appliance in the building-in niche
- Preparing to install the front panels
- Securing and aligning the furniture front
- Mounting the fixing brackets
- Securing the covers
- Installing the cover in a side-by-side combination
- Securing the plinth ventilation grille and plinth panel
- Limiting the opening angle of the appliance door
- Mains water connection
- Electrical connection
- Saving energy
- Guide to the appliance
- Accessories
- Initial commissioning
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Super cool and Super freeze
- Temperature and door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Freezing and storing food
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Water filter
- Problem solving guide
- Noises
- Service
- EU Conformity declaration
- UK Conformity declaration
- Copyrights and Licences
Problem solving guide
126
Problem Cause and remedy
Water is flowing out of
the refrigeration appli-
ance.
The water inlet is faulty.
Close the stopcock immediately.
Check whether the water line is damaged.
Contact the Miele Customer Service Department.
Check whether the water pressure is too high.
If the water pressure is too high, this can cause leaks
(see “Mains water connection” in ”Installation”).
Check whether the water pressure is between
200kPa and 800kPa (2bar and 8bar).
Check whether an incorrect valve has been in-
stalled.