Operating instructions/Installation instructions

Installation
*INSTALLATION*
33
 Carefully guide a flat-head screw-
driver through the plinth ventilation
grille on both sides and use it to
push the internal plastic latches out-
wards to release the plinth ventilation
grille.
 Place the plinth ventilation grille to
one side.
5
6
 Affix edge protection to the adja-
cent furniture fronts.
 Insert the plug connector at the back
of the refrigeration appliance (see “In-
stallation – Electrical connection”).
 Insert the plug into the socket.
The electrical socket must not be
concealed behind the appliance and
must be easily accessible in an
emergency.
 Risk of damage due to electrical
overload.
If the refrigeration appliance is elec-
trically overloaded, this can cause a
short circuit and thus damage your
refrigeration appliance.
When you install appliances side by
side, each refrigeration appliance
must have its own separate electrical
socket.
Tip: Secure the power cable to prevent
it becoming caught: tie a piece of string
to the middle of the cable and as the re-
frigeration appliance is being pushed
into the niche, pull the cable forward
underneath the appliance.
 Carefully push the refrigeration appli-
ance into the niche.
 If the refrigeration appliance cannot
be pushed into the niche (because
the floor is uneven, for example), un-
screw the rear adjustable feet slightly
(see “Installation – Aligning the refri-
geration appliance”) and slide the re-
frigeration appliance into the niche.
 Remove the edge protection from
the adjacent furniture fronts.