Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Installation
- Location
- Installation notes
- Specifications for the mains water connection
- Building-in dimensions
- Dimensions of front panels
- Installing the appliance
- Before starting ...
- Tools required
- Weight of the furniture fronts
- Aligning the building-in niche
- Checking the installation niche
- Before installation
- Preparing the building-in niche
- Pushing the refrigeration appliance into the building-in niche
- Aligning the refrigeration appliance
- Securing the refrigeration appliance in the building-in niche
- Preparing to install the front panels
- Securing and aligning the furniture front
- Mounting the fixing brackets
- Securing the covers
- Installing the cover in a side-by-side combination
- Securing the plinth ventilation grille and plinth panel
- Limiting the opening angle of the appliance door
- Mains water connection
- Electrical connection
- Saving energy
- Guide to the appliance
- Accessories
- Initial commissioning
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Super cool and Super freeze
- Temperature and door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Freezing and storing food
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Water filter
- Problem solving guide
- Noises
- Service
- EU Conformity declaration
- UK Conformity declaration
- Copyrights and Licences
Installation
*INSTALLATION*
44
Measure the gap Z between the
mounting frame for the lower appli-
ance door and the upper appliance
door.
Maintain a gap of 3mm to the upper
front panel.
To fit the front panel to the lower appli-
ance door, repeat the steps starting
from "Preparing to install the front
panel”.
Mounting the fixing brackets
The fixing brackets are used to addi-
tionally secure the front panels to the
bottom of the appliance doors.
Do not mount the fixing brackets until
the appliance (or side-by-side com-
bination, if applicable) has been in-
stalled and the front panels have been
aligned.
Open each appliance door as far as it
will go.
Slide each fixing bracket sideways
onto the screw at the bottom of the
appliance door.