Operating and Installation Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Installation information
- Installation dimensions
- Building in the appliance
- Before starting...
- Tools required
- Aligning the installation niche
- Checking the installation space
- Before installation
- Preparing the installation niche
- Pushing the appliance into the niche
- Aligning the appliance
- Securing the appliance in the niche
- Securing the base cover plate and the baseboard
- Aligning the appliance doors
- Adjusting the door opening angle (optional accessory)
- Electrical connection
- Water connection
- How to save energy
- Guide to the appliance
- Accessories
- Before first use
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Automatic SuperCool and SuperFreeze
- Temperature and door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Freezing and storing food
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Water filter
- Technical Service
- Declaration of conformity
- Leere Seite
Frequently Asked Questions
104
Problem Possible cause and solution
The compressor is
switching on more fre-
quently and for longer
periods of time, so the
temperature in the ap-
pliance is dropping.
The ventilation slits in the cabinetry have been cov-
ered or become too dusty.
Do not block the ventilation slits.
Clean the ventilation slits on a regular basis.
The doors have been opened too frequently, or a
large amount of fresh food has been put in at once for
storage or freezing.
Only open the doors when necessary and for as
short a time as possible.
After a while the temperature will return to normal by
itself.
The doors are not properly closed. A thick layer of ice
may have formed in the freezer.
Close the appliance doors.
After a while the temperature will return to normal by
itself.
If a thick layer of ice has formed, it will decrease the
cooling capacity and increase the energy consump-
tion.
Defrost the appliance and clean it.
The room is too warm. The higher the room tempera-
ture, the longer the compressor has to run.
See “Installation location”.
The appliance was not properly installed in the niche.
See “Installation - Building in the appliance”.
The compressor is
switching on more fre-
quently and for longer
periods of time, so the
temperature in the ap-
pliance is dropping.
The temperature setting is too low.
Correct the temperature setting.
A large amount of food is being frozen at once.
See “Freezing and storing food”.
The SuperCool function is still switched on.
To save energy, you can turn SuperCool off your-
self.
The SuperFreeze function is still switched on.
You can turn off the Automatic SuperCool function
earlier to save energy.