Operating and Installation Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Installation information
- Installation dimensions
- Building in the appliance
- Before starting...
- Tools required
- Aligning the installation niche
- Checking the installation space
- Before installation
- Preparing the installation niche
- Pushing the appliance into the niche
- Aligning the appliance
- Securing the appliance in the niche
- Securing the base cover plate and the baseboard
- Aligning the appliance doors
- Adjusting the door opening angle (optional accessory)
- Electrical connection
- Water connection
- How to save energy
- Guide to the appliance
- Accessories
- Before first use
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Automatic SuperCool and SuperFreeze
- Temperature and door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Freezing and storing food
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Water filter
- Technical Service
- Declaration of conformity
- Leere Seite
Before first use
55
Remove the label from the foil and
stick it onto the frame of the dry com-
partment (see “Product description”).
Tip: If you are not satisfied with the po-
sitioning of the labels, you can easily
pull them off and stick them on again.
In addition, they can be removed with-
out leaving any residue.
Inserting the Active AirClean filters
Your refrigeration appliance is equipped
with 2Active AirClean filters which neu-
tralize unpleasant odors in the Fridge
Zone.
The holder for the Active AirClean filters
is located under each of the shelves in
the Fridge Zone.
To remove the holder for the Active
AirClean filters, press against the re-
tainers on both sides of the holder
from the rear and pull the holder
downwards diagonally from the shelf.
Insert the two Active AirClean filters
supplied with the surrounding edge
pointing downwards into the holder.
To replace the holder, press against
the retainers on both sides from the
rear and, using the retainers, clamp it
into the gap on the shelf from below.