Operating and Installation Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Installation information
- Installation dimensions
- Building in the appliance
- Before starting...
- Tools required
- Aligning the installation niche
- Checking the installation space
- Before installation
- Preparing the installation niche
- Pushing the appliance into the niche
- Aligning the appliance
- Securing the appliance in the niche
- Securing the base cover plate and the baseboard
- Aligning the appliance doors
- Adjusting the door opening angle (optional accessory)
- Electrical connection
- Water connection
- How to save energy
- Guide to the appliance
- Accessories
- Before first use
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Automatic SuperCool and SuperFreeze
- Temperature and door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Freezing and storing food
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Water filter
- Technical Service
- Declaration of conformity
- Leere Seite
Selecting additional settings
63
Touch the sensor control to return
to the previous menu level.
- Adjusting the intensity
You can also adjust the intensity of the
Push2Open function. The lower the in-
tensity, the less force required when
pushing against the door.
In settings mode , use the and
arrow buttons to select Door Assistant
and select OK to confirm your selec-
tion.
In settings mode , use the and
arrow buttons to select Intensity and
select OK to confirm your selection.
Use the and arrow buttons to
select the desired intensity (Low,
Medium, High) and touch OK to con-
firm your selection.
- Adjusting the duration of the Auto-
Close function
You can also adjust the duration for
how long the appliance door will remain
open until it closes automatically.
In settings mode , use the and
arrow buttons to select Door Assistant
and select OK to confirm your selec-
tion.
In settings mode , use the and
arrow buttons to select AutoClose and
select OK to confirm your selection.
Use the and sensor controls to
select the duration (5 to 30 seconds)
and touch OK to confirm your selec-
tion.
To protect against inadvertent open-
ing: if you do not pull the appliance
open, it will close again by itself after a
duration defined by you (see “Set Au-
toClose duration”).
Pull2Open
In settings mode, use the and
arrow buttons to selectDoor Assistant
and selectOK to confirm your selec-
tion.
Use the and arrow buttons to
selectMode and touchOK to confirm
your selection.
Use the and arrow buttons to
selectPull2Open and touchOK to
confirm your selection.
Touch the sensor control to return
to the previous menu level.
– Adjusting the intensity
You can also adjust the intensity of the
Pull2Openfunction. The lower the inten-
sity, the less force is required when
pulling the door.
In settings mode, use the and
arrow buttons to selectDoor Assistant
and selectOK to confirm your selec-
tion.
In settings mode, use the and
arrow buttons to selectIntensity and
selectOK to confirm your selection.
Use the and arrow buttons to
select the desired intensity (Low,
Medium, High) and touchOK to con-
firm your selection.